The chain and the support are located beside the splice box. The energy supply chain is used to protect X-ray cables and hoses while moving the telescope. Splice box, 12 cores outdoor (IP65) FTTH box, 6x SC duplex, w/o adaptors FTTH outdoor box for 6 adaptors SC duplex with key. The N2P control box is located on the frame of the slice box and includes a pressure sensor, a manometer, a 0-pressure switch and push buttons for opening/closing the splice box. The external part of the fixed tube is heat insulated as well. The movable tube of the splice box is equipped with an internal heat insulated protection tube. In a CCV line, the base of the splice box is fastened to the extruder platform and the angle of the splice box can be adjusted depending on the catenary factor of the line. The tube is insulated from the cold, in order to reduce the amount of by-product. The size of the flange, which is connected to the CV tube, is selected according to the CV tube. The fixed tube of the splice box is equipped with a gas circulation pipe point. Splice to Romex or another wire up to a max 14 gauge max with this splice box assembly. The frame of the splice box is the fixing point of the whole CCV line and must be fastened properly to the floor construction according to given forces. xSiCute IP68 rated moulded plastic external splice box suitable for protecting up to. The basic machine consists of a frame, a movable tube, a shifter mechanism for the movable tube and heat insulation for the movable tube. External IP68 FTTx 24 Fibre Splice Box (48 Fibres With Optional Trays). The opening and closing of the splice box is achieved by push-buttons on the N2P control box. SELLER MAKES NO EXPRESS OR IMPLIED WARRANTIES OF ANY KIND INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE OTHER THAN STATED HEREIN.The splice box consists of a steel frame, movable and fixed tubes, a sealing tube and electrical transfer equipment. PURCHASER SHALL TRANSPORT THE MERCHANDISE, AT PURCHASER’S EXPENSE, TO SELLER’S FACILITY FOR REPAIR. THE EXCLUSIVE REMEDY FOR ANY CLAIM UNDER THIS LIMITED WARRANTY SHALL BE THE OBLIGATION OF SELLER TO REPAIR OR REPLACE THE MERCHANDISE WHICH SHALL BE DETERMINED TO THE SATISFACTION OF SELLER UPON SELLER’S EXAMINATION TO HAVE BEEN THUS DEFECTIVE. For all merchandise not specifically listed above, any claim for breach of this limited warranty must be made in writing within one (1) year after delivery of such merchandise to Purchaser.If the merchandise is a P, PA, or PJ Series Pump purchased with an extended warranty, any claim for breach of this limited warranty must be made in writing within five (5) years after delivery of said pump to the Purchaser.If the merchandise is a PF Series Pump purchased with an extended warranty, any claim for breach of this limited warranty must be made in writing within five (5) years after delivery of said pump to the Purchaser. FDX 20 series DIN rail splice box, equipped with 6x SC duplex couplings, fully assembled and ready for splicing with pre-assembled 900 µm pigtails (OM4) and splice holder (for separately sold shrink and crimp splice protection) on a patented splice comb made from powder-coated sheet steel.If the merchandise is a Grundfos Effluent and Solids-Handling Pump, PEF and PSE Series, any claim for breach of this limited warranty must be made in writing within one and a half (1.5) years from the date of installation or two (2) years from the date of manufacture of said pumps.If the merchandise is an FRP Septic Tank Half-Shell, any claim for breach of this limited warranty must be made in writing by the Orenco Distributor or Dealer within five (5) years from the date of shipment of the FRP Septic Tank Half-Shell to the Distributor or Dealer.If the merchandise is a control panel, any claim for breach of this limited warranty must be made in writing within three (3) years after delivery of the control panel to the Purchaser.If the merchandise is a Biotube® Effluent Filter for Residential Applications, any claim for breach of this limited warranty must be made in writing but it can be made at any time after delivery of the Biotube® Effluent Filter to the Purchaser.If the merchandise is an AdvanTex® Treatment System for Residential Applications or for Commercial and Multi-Family Applications, any claim for breach of this limited warranty must be made in writing within three (3) years from the date of installation in the appropriate application, as long as the System is continuously covered by a service contract provided by an Orenco authorized service provider.Claims for a breach of this limited warranty shall be made as follows: Subject to the exclusions, limitations, and conditions contained herein, Seller warrants that all merchandise will be free from defects in workmanship.
0 Comments
Leave a Reply. |